Saves Nails Solvent Based Gap-Filling Adhesive

Name: Saves Nails Solvent Based Gap-Filling Adhesive

A multi‐purpose, rubber based construction adhesive in mild solvents, that can replace mechanical fixings in a wide variety of domestic, commercial and industrial applications.

Features: Instant grab. – Slump resistant. – Gap-filling properties bridging gaps up to 12mm. – Can be used in all weather conditions. – Suitable for rough and porous surfaces. – Over paintable. – Good low temperature resistance. – For interior and exterior use. – Toluene-free formulation.

Application: Ideal for fixing a wide variety of materials including aluminium, steel, wood, chipboard, plasterboard, ceramic tiles, PVCu cladding and building panels, brick, some plastics*, marble, stone, brick veneer, concrete, (*solvent attack can occur with some plastics so test suitability before use). It can also be used to fix skirting boards, door surrounds and frames, window sills, all types of cladding, wall battens, decorative wall boards, metal carpet edges, automotive trims and much more. Can also be used to bond stair nosings, gripper rods, laminates and temporary bonding of polythene dust proofing. It has good low temperature resistance so suitable for for freezers and cold applications.

Instructions: Preparation: Ensure all surfaces are clean, dry and free from grease or any contaminants that may hinder adhesion.
Application: Apply using a standard sealant gun with the nozzle cut at an angle of 45°, and to an opening slightly larger than the joint to be sealed. Puncture membrane at base of nozzle using a long wood nail. Apply a 6mm bead (or thicker to suit gap) in a zig zag along one length of the item to be fixed. Press into place and apply an even pressure on the entire surface, leave to cure for 48 hours. Temporary support or fixings are recommended on very heavy items whilst curing. Bracing or additional mechanical fastening is recommended for ceiling or heavy wall panels while the adhesive develops full strength. When bonding foam to ceiling additional mechanical fastenings are to be used.
Cleaning: Excessive material can be removed using Bond It White Spirit or cellulose thinners, before product cures. Clean tools immediately after use.

Limitations: Not suitable for areas subject to frequent water immersion.
Not recommended for use on asphalt, bitumen or polystyrene.
Not to be used as a mirror adhesive.
Dusty or porous surfaces should be primed prior to application of adhesive.