Incredibond Solvent-Free Fibre Reinforced Adhesive

Name: Incredibond Solvent-Free Fibre Reinforced Adhesive

A fibre reinforced, high strength, solvent-free, instant grab adhesive that sticks almost anything to anything. Can be used as an alternative to screws and nails. Has a high dry bond strength and a higher dry bond strength than the majority of hybrid polymer adhesives/sealants. For interior and exterior use (see data sheet for exceptions).

Features: Fibre reinforced.- High strength: Initial grab in excess of 2000N/m2 . – High dry bond strengths to match those achieved by solvent based grab adhesives. – Higher dry bond strength than the majority of hybrid polymer type adhesive/sealants. – Solvent‐free, low odour, no VOC emissions. – Excellent adhesion to a wide range of construction materials. – Can be used as an alternative to screws and nails. – For interior and exterior use.* (*in sheltered external positions only and not if subjected to water immersion).

Application: Suitable for fixing skirting boards, dado rails, coving, architraves, polystyrene mouldings and key holders. For use with most common building materials, wood, OSB, chipboard, concrete, plaster, mortar, ceramic, metal (galvanised) steel, uPVC and most plastics. Note: at least one surface must be porous otherwise drying times will be significantly longer. It has a higher initial wet tack, so can hold more weight immediately. It has a higher bond strength, so in theory, you would need to use less INCREDIBOND than a solvent-free adhesive. It also has better adhesion to some plastics, like uPVC.

Instructions: Preparation: Ensure all surfaces are clean, dry and free from grease, dust or any contaminants or loose material that may hinder adhesion. Friable surfaces or laitance must be removed prior to application.
Application: Carefully cut the tip of the cartridge taking care not to damage the threaded area. Screw on the nozzle supplied and cut to the desired bead size. Apply using a standard sealant gun. Apply a continuous bead of adhesive to one surface and press the 2 parts together as hard as you can or tamp lightly with a rubber mallet. Load can be applied after 24 to 48 hours. Heavy items may need to be underpinned or temporarily supported for 48 hours. For panels and larger objects, apply 6mm beads at 20cm centres. Cleaning: Tools should be washed with soapy water immediately after use.

Limitations: Do not use in very wet or continuous water immersion environments. Do not use on polythene, polypropylene, asphalt or bitumen. Certain substrates may require priming. Always test a small inconspicuous area prior to use.