Cover-It Hardfloor Protector Rolls

Name: Cover-It Hardfloor Protector Rolls

High performance, self-adhesive protection material for covering and protecting hardfloors and windows. Protects against mess, dirt, spillages and staining, etc. whilst painting and decorating, plastering, tiling and general building and maintenance projects. Ideal for covering glass/windows when painting window frames and sills.

Features: Protects against costly damage to most surfaces. – Easy application, simply unwind and cover-it. – Waterproof, good against paint and liquid spillages. – Safer to use than loose dust sheets and covers as it adheres to the surface. – Quick removal. – Heavy duty. – Can be left down for up to 4 weeks.

Application: Easy to apply simply roll onto the floor or surface being protected and adhere it firmly to the material to be covered. In areas of heavy traffic, e.g. doorways, repeat application may be required. Cover-It can be applied over itself provided the surface is free from dust, moisture and grease. Glass/ Windows – this product is also suitable for use on windows when painting window frames and sills. To remove:- the low tack adhesive will allow for easy removal. Lift each edge in turn and pull back ensuring any spills are covered and cannot escape before lifting the whole sheet.

Instructions: Preparation: Perform a compatibility test on an inconspicuous area prior to full application. Ensure the surface is free from dust, moisture and grease prior to application.
Flooring – Place the roll onto the floor with the open end facing away from the direction it is to be applied. Unpeel approx 300mm (12”) of the protective cover and adhere it firmly to the surface. Simply push the roll forward slowly using either your foot or a soft brush, making sure it follows a straight line, smoothing it out as it unwinds to eliminate air bubbles or creases. Ensure film is safely and securely positioned before commencing work.
Other Surfaces – Unpeel approx 300mm (12”) of COVER-IT and adhere it to the surface firmly by hand, simply unwind the roll smoothing down as you push the roll forward covering the surface.
Removal: Easy and simple – the low tack adhesive will allow for easy removal. Lift each edge in turn and pull back towards the middle to keep any contaminants central on the roll ensuring any spills are covered and cannot escape before lifting the whole sheet.

Limitations: In rare circumstances, COVER-IT can leave sticky residues on certain surfaces so it is recommended test areas be carried out prior to application.
– Always check that COVER-IT is securely adhered to the surface before commencing any work to reduce slips, trips and falls.
– Replace COVER-IT after 4 weeks. Any unexpected residue can be easily removed by hand or with Bond It MULTI-WIPES – dependant on surface, check the compatibility of any surfaces with the wipes in an inconspicuous area first. Bond It FOIL SAFE CLEANER may also be used if the surface is suitable.
– Do not use underfloor heating whilst COVER-IT is in position or 24 hours prior to application.
– In heavily trafficked areas or if exposed to excessive light or heat, replace at least once a week, checking for any residues left on the surface.
– Disposable – single use only.
– Slippery when wet.