Cover-It Carpet Protector Rolls 50m

Name: Cover-It Carpet Protector Rolls

High performance, self-adhesive protection material for covering and protecting carpets and textiles. Protects against mess, dirt, spillages and staining, etc. whilst painting and decorating, plastering, tiling and general building and maintenance projects.

Features: Protects against costly damage to most surfaces. – Easy application, simply unwind and cover-it. – Waterproof, good against paint and liquid spillages. – Safer to use than loose dust sheets and covers as it adheres to the surface. – Quick removal. – Heavy duty. – Can be left down for up to 4 weeks. – Excellent for stairs.

Application: Easy to apply simply roll onto the floor or surface and adhere it firmly to the material to be covered. In areas of heavy traffic, e.g. doorways, repeat application may be required. Cover-It can be applied over itself provided the surface is free from dust, moisture and grease. To remove:- the low tack adhesive will allow for easy removal. Lift each edge in turn and pull back ensuring any spills are covered and cannot escape before lifting the whole sheet.

Instructions: Preparation: Perform a compatibility test on an inconspicuous area prior to full application. Ensure the surface is free from dust, moisture and grease before application. Place the roll onto the floor with the open end facing away from the direction it is to be applied. Unpeel approx 300mm (12”) of the protective cover and press it to the surface firmly by hand. Push the roll away from you making sure it follows a straight line, smoothing it out as it unwinds to eliminate air bubbles or creases. Ensure film is safely and securely positioned before commencing work.
Removal: Easy and simple – the low tack adhesive will allow for easy removal. Lift each edge in turn and pull back towards the middle to keep any contaminants central on the roll ensuring any spills are covered and cannot escape before lifting the whole sheet. Take care when removing from textiles with loosely held fibres or fringes.

Limitations: DO NOT use on long pile/ wool carpets. – In rare circumstances, COVER-IT can leave sticky residues on certain surfaces so it is recommended test areas be carried out prior to application.
– Replace COVER-IT after 4 weeks. Any unexpected residue can be easily removed by hand or with Bond It MULTI-WIPES – dependant on surface, check the compatibility of any fabric dyes with the
wipes in an inconspicuous area first.
– Check textiles carefully before application – any textiles with lightly held fibres or fringes may detach when the film is removed the user should inspect textiles for any potential weak points
before application.
– Do not use underfloor heating whilst COVER-IT is in position or 24 hours prior to application.
– In heavily trafficked areas or if exposed to excessive light or heat, replace at least once a week, checking for any residues left on the carpet.
– Carpets newly laid using adhesive will require 72 hours for the vapours to dissipate before application of COVER-IT film.
– COVER-IT will not adhere to damp or wet textiles. Recently cleaned carpets and uncured concrete floors: after film application moisture vapour is prevented from escaping and may
cause discolouration of carpet fibres.
– Disposable – singular use only.
– Not suitable for hard surfaces, rugs or loose carpet tiles.
– Slippery when wet.