Mega Stik PU Adhesive

Name: Mega Stik PU Adhesive

A fast curing, PU adhesive foam that has been specially developed for the rapid installation of plasterboard, insulation boards, floorboards and roof decking. Supplied in an aerosol can, the product can be used with a standard foam gun. A multi-purpose, polyurethane construction adhesive in a can – but not just a dry wall adhesive. The cured adhesive is an excellent heat insulator and has exceptionally good adhesion properties. Can also be used to dampen sound.

Features: No mixing, no mess, no water, no dust! – No need to carry heavy bags of plaster. – One can fixes approximately 5 standard plaster boards. – 30% time saving over conventional dry wall adhesives. – Can be plastered in 1 hour. – Can be applied direct to boards or the wall either horizontally or vertically. – Can works on solid walls, metal and timber studding, battens and beams. – No nails or screws required.

Application: A fast curing adhesive foam that has been specially developed for the rapid installation of plasterboard, insulation boards, floorboards and roof decking. Supplied in an aerosol can, application is by universal foam gun. Ideal for the installation of insulation boards and plaster boards to solid walls, metal and timber stud walls and battens. For fixing roof decking and floorboards to beams. And in place of backing rods in expansion joints and around window and door frames. It adheres to most common building materials:- extruded and expanded polystyrene; mineral wool; polyisocyanurate and polyurethane foam; plaster, gypsum boards; concrete, brick, stone; wood; metals; bituminous membranes.

Instructions: Preparation: Protect all surfaces from drips of foam by using paper or plastic sheets. As the foam needs moisture to cure to achieve best results mist the substrate with water prior to application.
Application: As from 24 August 2023 adequate training is required before industrial or professional use. The instructions for the can must strictly be observed. Use gloves and eye protection and avoid skin contact. If necessary, gently warm chilled cans in lukewarm water before use. Do not heat cans above +50°C as there is risk of bursting. Shake the can for at least 30 seconds then fix the foam gun to the can. The can will operate in any position. If fixing boards, apply beads to the back of the board wait approximately 2 minutes then press the board into place. If using insulation board apply 3 beads approximately 25mm wide to the board. If using plasterboard apply approximately 400mm apart. Use mechanical fixings if working overhead. Apply the boards in rows, starting from the bottom of the wall, and going up to the top to avoid sliding. Apply to the substrate within 5 minutes of applying adhesive (depending on ambient conditions) and press firmly across the whole face of the board, starting at the top. Apply subsequent boards ensuring edges are firmly butted up at this stage. Hold board in place for approx 1 minute until adhesive is cured enough to hold the board on its own. Plastering can commence after 1 hour! If using a gun and you have not used all the can, clean the gun using Bond It Gun Foam Cleaner, screw in proportioning screw which will ensure the foam will be usable for up to approximately 4 weeks. Cleaning: Excess foam can be removed whilst still wet using Bond It Foam Cleaner or Multi-Wipes. Cured foam can only be removed mechanically.

Limitations: Cured foam is sensitive to UV light and direct sunlight and therefore should be covered with suitable opaque sealant, filler, paint or other material. Not recommended for use on polyethylene, silicone, oil and grease or Teflon.